Rockwell Automation 7000A PowerFlex Medium Voltage AC Drive (A Frame) - ForGe Control (PanelView 550) - Manual (Page 116)

3-56 Operator Interface
7000A-UM151D-EN-P – March 2013 7000 “A” Frame
Parameter Transfers The parameters used by the drive are stored within the drive itself.
The operator interface is used to review and modify these parameters.
When a Drive Control Board is changed, it is necessary to re-enter
the parameters into the new board. The operator interface can
simplify this process by reading all the parameters from the old
Drive Control Board and storing them either in the operator interface
or on a flash card. When the new board has been installed, the
previously stored parameters are then downloaded to the new board.
The flash card provides an added benefit when more than one drive
is using the same set of parameters. Parameters can be entered on
the first drive, then uploaded and stored on the flash card. The flash
card may then be taken to the remaining drives and the parameters
downloaded to those drives.
Note: This feature does not replace the saving of parameters to the
Drive NVRAM, refer to section Store/Retrieve Configuration.
After downloading parameters, they must still be saved within the
drive in order to make them permanent.
To transfer parameters, press the [F4] key from the TRANSFER
screen. The screen shown in Figure 3.80 will be displayed. (If
nothing happens, then you have not gained the required access to
modify the flash memory. Exit to the TRANSFER screen and refer
to the section entitled Enter/Modify an Access Level to gain
access). Within this screen it is possible to perform four different
parameter transfers.
Figure 3.80 – Transfer Parameters Menu