Rockwell Automation 7000A PowerFlex Medium Voltage AC Drive (A Frame) - ForGe Control (PanelView 550) - Manual (Page 90)

3-30 Operator Interface
7000A-UM151D-EN-P – March 2013 7000 “A” Frame
Figure 3.34 – Access Level Changed
When the desired operations have been completed, the operator
interface should be placed back to the 'Monitor' level in order to
protect against unauthorized modifications. From this screen press
the [F8] key. The level will change back to 'Monitor' as shown in
Figure 3.32.
The default value for the password (PIN) of the 'Basic' and
'Advanced' levels is zero (0), or simply pressing the [enter] key. This
value can be changed from the ACCESS screen. First use the
up/down cursor keys to select the level for which you wish to modify
the PIN. Press the [F9] key. The typical PASSWORD CHANGE
screen shown in Figure 3.35 is displayed, showing the Access Level
for which the new PIN will be applied to.
Figure 3.35 – PIN Change
Enter the current PIN value via the data keys [0]-[9] and press the
[enter] key. As in the ACCESS screen, the entered value is shown via
placeholders and may be edited with the [backspace] key.
If you entered the correct PIN, the screen now asks you for the new
PIN. Type in the new PIN value using the data entry keys [0]-[9]
followed by the [enter] key. The screen now asks you to verify the
new PIN. Type in the new PIN again followed by the [enter] key as
shown in Figure 3.36.