Rockwell Automation 7000A PowerFlex Medium Voltage AC Drive (A Frame) - ForGe Control (PanelView 550) - Manual (Page 77)

Operator Interface 3-17
7000 “A” Frame 7000A-UM151D-EN-P – March 2013
Setting Date
The calendar setting controls the date stamp that the drive uses on
the information contained on the alarm summary screen. To change
the date, press the [F4] key. The year position of the calendar will be
in reverse video (Figure 3.14). Press the [cursor up] or [cursor
down] keys to change the value by a resolution of 1 unit. Press the
[cursor left] and [cursor right] keys to change the value by a
resolution of 10 units. To change the month press the [F4] key again
and repeat the procedure. Likewise, to change the day, press the [F4]
key again. Each press of the [F4] key will highlight the next position
of the calendar. The highlighted position may be modified via the
cursor keys.
To abort the change, press the [backspace] key and the calendar will
return to its original date. To accept the change, press the [enter]
key. The new calendar setting has been recorded.
The setting may also be aborted by pressing any of the assigned
function keys (other than F1 and F4). The function associated with
that key will be executed.
You can not set the day of the week. The operator interface will
determine the day of the week based on the date that you set in the
calendar.
Figure 3.14 – Utility Date
Selecting Meters
The utility screen (Figure 3.10 ) shows the four tags assigned to the
four meters on the 'Top Level Menu'. These can be changed by
pressing the [F8] key. This displays a new screen (Figure 3.15) from
which the selection and text associated with the meter is changed.