Rockwell Automation 2198-Hxxx Kinetix 5500 Servo Drives User Manual - Manual (Page 235)

Rockwell Automation Publication 2198-UM001D-EN-P - May 2014 235
Appendix
F
History of Changes
This appendix summarizes the revisions to this manual. Reference this appendix
if you need information to determine what changes have been made across
multiple revisions. This may be especially useful if you are deciding to upgrade
your hardware or software based on information added with previous revisions of
this manual.
2198-UM001C-EN-P,
February 2014
Topic Page
2198-UM001C-EN-P, February 2014 235
2198-UM001B-EN-P, September 2013 236
Change
Added Hiperface-to-DSL feedback converter kit installation instructions to table.
Added Hiperface-to-DSL feedback converter kit to system overview table.
Added Kinetix VP (Bulletin VPS) stainless-steel motors to the system overview table and throughout the manual.
Added Hiperface-to-DSL feedback converter kit and compatible MP-Series motors and actuators to configuration
diagrams.
Added Hiperface-to-DSL converter kit and footnote to noise zone diagram.
Added Hiperface-to-DSL converter kit and footnote to motor feedback in table.
Added paragraph describing motor feedback types accepted by the Hiperface-to-DSL converter kit.
Added section to support wiring the motor power/brake and feedback connectors when using the Hiperface-to-DSL
converter kit.
Updated Configure Feedback Only Axis Properties to include the Bulletin 842E-CM integrated motion encoder on the
EtherNet/IP network.
Added Kinetix VP (Bulletin VPS) stainless-steel motors to the Kinetix VP interconnect diagram.
Added interconnect diagrams to support wiring the motor power/brake and feedback connectors when using the
Hiperface-to-DSL converter kit.
Added History of Changes appendix.