Rockwell Automation 2198-Hxxx Kinetix 5500 Servo Drives User Manual - Manual (Page 95)

Rockwell Automation Publication 2198-UM001D-EN-P - May 2014 95
Connecting the Kinetix 5500 Drive System Chapter 5
Capacitor Module
Connections Follow these guidelines when wiring the 2198-CAPMOD-1300 capacitor
module:
• Wire relay output (MS) connections to the Logix5000 controller
(optional).
• Refer to
Kinetix 5500 Capacitor Module wiring example on page 191 .
• Refer to
Kinetix 5500 Capacitor Module Status Indicators on page 147 for
troubleshooting the module status indicator and relay output.
• Refer to the installation instructions provided with your Bulletin 2198
capacitor module, publication 2198-IN004 .
Figure 55 - Capacitor Module Wiring
Table 48 - Capacitor Module Connector Specifications
IMPORTANT To improve system performance, run wires and cables in the wireways as
established in
Chapter 2 .
Connections to the DC bus and 24V control power must be made with the
shared-bus connection system.
2
1
3
4
1
2
Kinetix 5500 Capacitor Module
Top View
Kinetix 5500 Capacitor Module
Front View
Item Description
1 Module status (MS) connector (relay output)
2 Module status indicator
3 DC bus (DC) connector (under cover)
(1) (2)
(1) The DC bus connector ships with a protective knock-out cover
that can be removed for use in shared-bus configurations.
(2) The shared-bus connector set for the capacitor module, catalog
number 2198-KITCON-CAP1300, is included for connection to the
upstream drive. Replacement kits are also available.
4 24V control input power (CP) connector
(2)
Capacitor Module
Cat. No.
Pin Signal
Recommended
Wire Size
mm
2
(AWG)
Strip Length
mm (in.) Torque Value
N•m (lb•in)
2198-CAPMOD-1300
MS-1 RELAY+
0.14…1.5
(28…16)
7.0 (0.28)
0.22…0.25
(1.9…2.2)
MS-2 RELAY-