Rockwell Automation MPMA Integrated Multi-Axis Linear Stages User Manual
Page 34
34
Rockwell Automation Publication MPMA-UM001B-EN-P - November 2010
Chapter 4 Mounting and Connecting the MP-Series Integrated Multi-axis Linear Stage
4. Support cantilevered or secondary stage while removing crate shipping
platform.
Use a three-person lift to move the multi-axis stage.
Three-Person Lift - One person at each end of base stage grasping the
bottom of the stage near the ends. The third person will grasp the
cantilevered end or top stage by the stage base only and apply only enough
lift to balance the equipment.
The bottom stage should bare most of the weight and the top used for
balance only. Do not lift by the cover, side covers, or put pressure on the
strip seals.
5.
ATTENTION: Never use lifting straps to move the multi-axis
stage. Using lifting straps will deform covers and strip seals.
Always use a three-person lift to move the multi-axis stage.
WARNING: Do not remove stage shipping brackets until multi-
axis stage is fully installed. Removing stage shipping brackets will
allow the carriages to move unexpectedly which could cause
personal injury and damage to the equipment.
WARNING: Improper lifting of this product may result in personal
injury or damage equipment, never attempt to lift or move the
multi-axis stage by means other than those listed in this
publication.