Remove the cover, Install the cover, Remove the cover install the cover – Rockwell Automation MPMA Integrated Multi-Axis Linear Stages User Manual
Page 70
70
Rockwell Automation Publication MPMA-UM001B-EN-P - November 2010
Chapter 8 Removing and Replacing Multi-axis Stage Components
Remove the Cover
Follow these directions to remove a secondary stage cover.
1.
Remove strip seals following the strip seal removal procedure.
2.
Remove the four M4 screws securing the linear stage cover to the end caps.
3.
Remove the cover.
Install the Cover
Follow these directions to install a secondary stage cover.
1.
Start at the end cap nearest the magnetic cautionary label or the MP motor,
and install two M4 x 25 SHCS.
2.
Torque the M4 x 25 SCHS to 4 N•m (35 lb•in).
3.
Make sure the cover contacts the end cap.
4.
On the opposite end install two M4 x 30 SHCS and bottom out the screw.
The cover will not contact the end cap on this side and will float on the
screw.
M4 SHCS (2 per side)