Rockwell Automation MPMA Integrated Multi-Axis Linear Stages - Manual (Page 69)

Rockwell Automation Publication MPMA-UM001B-EN-P - November 2010 69
Removing and Replacing Multi-axis Stage Components Chapter 8
10. Slide the screws out of the bracket slots and lay carrier parallel to lower
stage.
11. Repeat step 3 through 10 for the base stage.
Cable Carrier Assembly
Installation
Follow the Cable Carrier Assembly Removal procedure for your multi-axis stage
in reverse adding the following steps when needed:
• Align the cable carrier using the alignment marks made when the worn
cable carrier was removed.
• Use Loctite 222 on all hardware during installation.
Remove the Strip Seal
Follow these directions to remove a strip seal.
Figure 14 - Linear Stage Seal Components
.
1. Loosen the strip seal clamps at each end of the linear stage.
2. Carefully grasp the end of the strip seal and slide it out of the linear stage.
IMPORTANT Handle strip seal material with care. The strip seal has sharp edges
that can cut if mishandled.
Stainless Steel
Strip Seal (2)
Strip Seal Clamp (4)
Seal Guide (4)
M3 SHCS (2x per guide)
M3 SHCS (8)