Rockwell Automation MPMA Integrated Multi-Axis Linear Stages - Manual (Page 72)

72 Rockwell Automation Publication MPMA-UM001B-EN-P - November 2010
Chapter 8 Removing and Replacing Multi-axis Stage Components
13. Adjust the seal guide by inserting a 0.8 mm (0.030 in.) shim between the
seal guide and the strip seal.
14. Return the linear stage to service.
Install the Side Cover
Follow these directions to install a side cover.
1. Insert a side cover into the base of the linear stage by holding it with the
top slightly tilted outward and hooking the bottom of the side cover in the
channel near the bottom of the base.
2. Starting at the end cap adjacent to the ground screw, install one M4 SHCS
and torque it to 4 N•m (35 lb•in).
3. On the opposite end install one M3 SHCS and torque it to 2.5 N•m
(20 lb•in).
Seal Guide
0.8 mm (0.03 in.) Shim
Strip Seal
TIP If installing the side cover with strip seals in place use a flat-blade
screwdriver to lift the side cover by inserting the screwdriver under
the cover between the cover and the base.