Rockwell Automation RECOMM-IBUS Interbus Communications Module - Manual (Page 13)

Getting Started 2-3
2.3 Installation Checklist
This section is designed to help experienced users start using the
Interbus module. If you are unsure about how to complete a step,
refer to the referenced chapter.
  Step Action Refer to
U 1 Review the safety precautions for the
module. Throughout
this manual
U
2 Verify that the drive is properly installed. SP600 AC
Drive User
Manual
U 3 Install the module.
Verify that the drive is not powered. Then,
connect the module to the network using a
Interbus cable and to the drive using the
Internal Interface cable. Use the captive
screws to secure and ground the module to
the drive. Chapter 3,
Installing the
Interbus
Module
U
4 Apply power to the module.
The module receives power from the drive.
Apply power to the drive. Refer to chapter 8,
Troubleshooting the Interbus Module and the
Network, if there is a problem. Chapter 3,
Installing the
Interbus
Module
U 5 Configure the module for your
application.
Set the parameters for the following features
as required by your application:
• I/O configuration.
• Fault actions.
Chapter 4,
Configuring
the Interbus
Module
U
6 Apply power to the Interbus master and
other devices on the network.
Verify that the master and network are
installed and functioning in accordance with
Interbus standards, and then apply power to
them.
U 7 Configure the scanner to communicate
with the module.
Use a network tool for Interbus to configure
the master on the network. Chapter 5,
Configuring
the Interbus
Scanner
U
8 Create a ladder logic program.
Use a programming tool to create a ladder
logic program that enables you to do the
following:
• Control the module and connected drive.
• Monitor or configure the drive using Explicit
Messages.
Chapter 6,
Using I/O
Messaging.
Chapter 7,
Using Explicit
Messaging
(Parameter
Protocol)