Rockwell Automation RECOMM-IBUS Interbus Communications Module - Manual (Page 2)

©2002 Rockwell Automation. All rights reserved.
The information in this manual is subject to change without notice.
Throughout this manual, the following notes are used to alert you to safety
considerations:
Important: Identifies information that is critical for successful application and
understanding of the product.
The thick black bar shown on the outside margin of this page will be used throughout
this instruction manual to signify new or revised text or figures.
!
ATTENTION:Identifies information about practices or circumstances
that can lead to personal injury or death, property damage, or
economic loss.
Interbus is a trademark of the Interbus Trade Organization.
Windows, Windows NT, and Microsoft are trademarks of Microsoft Corporation.
Reliance, SP600, VS Utilities, DPI, and SLC are trademarks of Rockwell Automation.
!
ATTENTION:The drive may contain high voltages that can cause
injury or death. Remove all power from the drive, and then verify power
has been removed before installing or removing an Interbus module.
Failure to observe these precautions could result in severe bodily
injury or loss of life.
ATTENTION:Only qualified electrical personnel familiar with drive and
power products and the associated machinery should plan or
implement the installation, start up, configuration, and subsequent
maintenance of the product using an Interbus module. Read and
understand this manual in its entirety before proceeding. Failure to
observe these precautions could result in bodily injury and/or damage
to equipment.
ATTENTION:DPI host products must not be directly connected
together via RECBL-xxx cables. Unpredictable behavior due to timing
and other internal procedures can result if two or more devices are
connected in this manner. Failure to observe this precaution could
result in bodily injury and/or damage to equipment.
ATTENTION:Comm Flt Action (6) lets you determine the action of the
module and connected drive if communications are disrupted. By
default, this parameter faults the drive. You can set this parameter so
that the drive continues to run. Precautions should be taken to ensure
that the setting of this parameter does not create a hazard of injury or
equipment damage. Failure to observe this precaution could result in
bodily injury and/or damage to equipment.
ATTENTION: When a system is configured for the first time, there
may be unintended or incorrect machine motion. Disconnect the motor
from the machine or process during initial system testing. Failure to
observe this precaution could result in bodily injury and/or damage to
equipment.
ATTENTION:If the Interbus module is transmitting control I/O to the
drive, the drive may fault when you reset the module. Determine how
your drive will respond before resetting the module. Failure to observe
this precaution could result in bodily injury and/or damage to
equipment
Trademarks not belonging to Rockwell Automation are property of
their respective companies.