Rockwell Automation RECOMM-IBUS Interbus Communications Module - Manual (Page 15)

Installing the Interbus Module 3-1
C
HAPTER
3
Installing the
Interbus Module
Chapter 3 provides instructions for installing the Interbus module on
an SP600 drive.
3.1 Preparing for an Installation
Before installing the Interbus module, verify that you have all
required equipment. Refer to chapter 2, Getting Started, for a list of
equipment.
3.2 Connecting the Module to the
Network
Step 1. Remove power from the drive.
Step 2. Use static control precautions.
Step 3. Route the Interbus cables through the bottom of the
SP600 drive. (See figure 3.1.)
Step 4. Connect the Interbus connectors to the cables. (See
figure 3.1 and tables 3.1 and 3.2.)
!
ATTENTION:The Interbus module contains ESD-
(Electrostatic Discharge) sensitive parts that can be
damaged if you do not follow ESD control procedures.
Static control precautions are required when
handling the module. Failure to observe these
precautions could result in damage to equipment.
!
ATTENTION:The drive may contain high voltages
that can cause injury or death. Remove all power
from the drive, and then verify power has been
removed before installing or removing an Interbus
module. Failure to observe these precautions could
result in severe bodily injury or loss of life.