Rockwell Automation RECOMM-IBUS Interbus Communications Module - Manual (Page 36)

5-6 Interbus Communications Module
This provides useful information regarding the CMD project
being created:
• “SP600 Interbus Demo” indicates what this project is
for.
• “SLC 5/05” indicates the controller used.
• “Interbus_SLC_Demo” indicates that
Interbus_SLC_Demo.RSS is the associated
RSLogix500 program used with this system.
Step 6. To configure the PC Com Port that CMD will use to
communicate with the SST scanner, click on Options/
Settings and then the Driver tab.
Step 7. Click on the Communication Path icon and then the
Standard tab.
Step 8. Select the port communication path. Typically, this is
“Serial Port” and “Com1” respectively, as shown in figure
5.7. Click OK until you return to the main screen.
Step 9. Right-click on the Controller Board icon and select
Type. Set the type to “IBS USC/4(4K)” and click OK. This
identifies the type of Interbus controller used on the SST
scanner. (See figure 5.8.)
Figure 5.7 – Selecting the Port Communication Path