Rockwell Automation RECOMM-IBUS Interbus Communications Module - Manual (Page 19)

Installing the Interbus Module 3-5
Step 4. For 1-20 HP SP600 drives: Fold the Internal Interface
cable behind the module and mount the module on the
drive using the four captive screws to secure and
ground it to the drive. See figure 3.2.
For 25-40 HP SP600 drives: Mount the module in the
drive using the four captive screws to secure and
ground it to the drive.
Important: All screws must be tightened to ground the module.
3.4 Applying Power
Step 1. Close the door or reinstall the cover on the drive. Key
status indicators can be viewed on the front of the drive
after power has been applied.
Important: Interbus compliance requires different LED
functions than what is normally displayed on the
front of the drive (DRIVE, MS, Net A, and Net B
LEDs). LED labels are provided with the module for
application to the drive cover.
Figure 3.1 – Mounting and Grounding the Interbus Module
!
ATTENTION:Unpredictable operation may occur
if parameter settings and switch settings are not
compatible with your application. Verify that
settings are compatible with your application
before applying power to the drive. Failure to
observe these precautions could result in severe
bodily injury or loss of life.
Adapter
Drive
Module
SP600 Drive
Internal Interface cable
folded behind the module
and in front of the drive