Rockwell Automation RECOMM-IBUS Interbus Communications Module - Manual (Page 7)

Contents VII
List of Tables
Table 2.1 – Equipment Shipped with the Interbus Module ......................... 2-2
Table 2.2 – Required User-Supplied Equipment ........................................ 2-2
Table 3.1 – Bus In Connector (From Previous Node on the Network)........ 3-2
Table 3.2 – Bus Out Connector (To Next Node on the Network)................ 3-2
Table 4.1 – Configuration Tools.................................................................. 4-1
Table 4.2 – PIDD / PODD Indexes ............................................................. 4-3
Table 4.3 – Module I/O Configuration Example .......................................... 4-4
Table 4.4 – Selections for Drive Response to Communication Fault.......... 4-5
Table 4.5 – Fault Configuration Parameters ............................................... 4-6
Table 4.6 – Module Configuration Status Parameters ............................... 4-8
Table 5.1 – Module Parameter Settings for Ladder Example ................... 5-2
Table 5.2 – Scanner I/O Layout ................................................................ 5-10
Table 5.3 – SLC Addressing for Device 1.0.............................................. 5-10
Table 5.4 – SP600 Parameter Settings for Ladder Examples .................. 5-15
Table 5.5 – G File Data Information.......................................................... 5-17
Table 7.1 – PCP Message Definition .......................................................... 7-3
Table 7.2 – Command Word Bit Descriptions............................................. 7-4
Table 7.3 – Command Message Format .................................................... 7-5
Table 7.4 – Reply Message Format............................................................ 7-5
Table 7.5 – PCP Read Main Program Data................................................ 7-6
Table 7.6 – PCP Read Subroutine Command Message ............................ 7-6
Table 7.7 – PCP Read Subroutine Reply Message.................................... 7-6
Table 7.8 – Command Message Format for PCP Writes.......................... 7-10
Table 7.9 – Reply Message Format for PCP Writes ................................. 7-10
Table 7.10 – PCP Write Main Program Data ............................................ 7-11
Table 7.11 – PCP Write Subroutine Command Message......................... 7-11
Table 7.12 – PCP Write Subroutine Reply Message ................................ 7-12
Table 8.1 – Cable Check (CC) Status Indicator: State Definitions.............. 8-2
Table 8.2 – Remote Bus Disable (RD) Status Indicator: State Definitions . 8-2
Table 8.3 – Transmit/Receive (TR) Status Indicator: State Definitions....... 8-2
Table 8.4 – Bus Active (BA) Status Indicator: State Definitions.................. 8-3
Table 8.5 – Bus Voltage (UL) Status Indicator: State Definitions ............... 8-3
Table 8.6 – Module Diagnostic Items.......................................................... 8-3
Table 8.7 – Event Codes and Descriptions................................................. 8-6