Rockwell Automation RECOMM-IBUS Interbus Communications Module - Manual (Page 27)

Configuring the Interbus Module 4-7
4.4.3 Resetting the Module
Changes to switch settings or some module parameters require that
you reset the module before the new settings take effect. You can
reset the module by cycling power to the drive or by using Reset
Module (5).
Set Reset Module (5) to Reset Module. See figure 4.4.
When you enter 1 (Reset Module), the module will be immediately
reset. When you enter 2 (Set Defaults), the module will set all
module parameters to their factory-default settings. The value of this
parameter will be restored to 0 (Ready) after the module is reset.
!
ATTENTION: If the module is transmitting control
I/O to the drive, the drive may fault when you reset
the module. Determine how your drive will respond
before resetting a connected module. Failure to
observe this precaution could result in bodily injury
or damage to the equipment.
Figure 4.4 – Reset Module Screen on an LCD OIM
Value Description
0 Ready (Default)
1 Reset Module
2 Set Defaults
Port 5 Device
RECOMM-IBUS
Parameter #: 5
Reset Module
1
Reset Module