Rockwell Automation RECOMM-IBUS Interbus Communications Module - Manual (Page 97)

Interbus Module Parameters B-5
I/O that the module is actively transmitting. The value of this
parameter will usually be equal to the value of DPI I/O Config (8).
Sets the Logic Command data that is sent to the drive if the
following is true:
• Comm Flt Action (6) is set to Send Flt Cfg and communications
are disrupted.
• Idle Flt Action (7) is set to Send Flt Cfg and the scanner is put into
Program or Test mode.
The bit definitions will depend on the product to which the module is
connected.
9 DPI I/O Active
Range: See figure B.2.
Default: See figure B.2.
Type: Read Only
Reset Required: N/A
Figure B.2 – DPI I/O Active (9)
0 0 0 1 0 x x x
0 1 2 3 4 5 6 7
1 = I/O Enabled
0 = I/O Disabled
x =Not Used
Cmd/Ref Datalink A Datalink B Datalink C Datalink D Not Used Not Used Not Used
10 Flt Cfg Logic
Range: 0000 0000 0000 0000 to 1111 1111 1111 1111
Default: 0000 0000 0000 0000
Type: Read/Write
Reset Required: No