Rockwell Automation MD65 Profibus Communication Card - Manual (Page 24)

3-8 PROFIBUS Communications Module
3.5 Connecting the Module to the Drive
Step 1. Remove power from the drive.
Step 2. Use static control precautions.
Step 3. Mount the module on the required special drive cover
(ordered separately).
• C Frame: Use the module screw to secure the module to
the cover.
• B Frame: Disregard the screw and snap the module in
place.
Important:For C Frame drives, tighten the module’s lower left screw
to ground the module. For B Frame drives, install the
special drive cover onto the drive using both cover
fasteners to ground the module.
Step 4. Connect the Internal Interface cable to the MDI port on
the drive and then to the MDI connector on the module.