Rockwell Automation MD65 Profibus Communication Card - Manual (Page 41)

Configuring the PROFIBUS Scanner 5-5
Step 5. Click on the (+) sign of the Slaves folder as shown in
figure 5.6.
The software tool will automatically create a Reliance Electric
sub-folder (in the Slaves folder) if it does not already exist. The
MDCOMM-PBUS is now shown in the library and the software tool
is now ready to configure a MDCOMM-PBUS on a PROFIBUS
network.
5.4 Configuring the SST-PFB-SLC
PROFIBUS Scanner
The following steps are performed to configure the SST-PFB-SLC
scanner using the SST PROFIBUS Configuration Software Tool. In
our example, the PROFIBUS network will consist of a SLC master
and two MD65 drives working in Single drive mode. The
configuration example is as follows:
• Drive 0: Ctrl/Stat & Ref/Fdbk enabled - Parameter Access
enabled
• Drive 1: Ctrl/Stat & Ref/Fdbk enabled - Parameter Access
enabled
The SLC processor must be in Program mode to configure the
scanner.
Step 1. Click on the (+) sign of the Masters folder in the Library
window to open the SST sub-folder. Available Profibus DP
masters are displayed in this sub-folder.
Figure 5.6 – Masters/Slaves Library Window