Rockwell Automation Energy Management Accelerator Toolkit Quick Start - Manual (Page 229)

Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014 229
FactoryTalk View ME Energy Faceplates Chapter 11
Configure ME PowerMonitor 500 Faceplates
The ME PowerMonitor 500 Faceplate files let you quickly load, configure, and use a preconfigured status display or
‘faceplate’ for the PowerMonitor 500 unit by using FactoryTalk View Machine Edition software.
These instructions are for the PowerMonitor 500 unit communicating over an EtherNet/IP network only.
Shows voltage, current, and frequency status.
Shows the power status.
Shows real, reactive, and apparent energy odometers.
Also lets the operator configure the device name for
display at the top of the faceplate.
The PowerMonitor 500 unit provides two user
configurable alarms (Virtual Alarm 1 and 2). The alarm
display indicates when either of these alarms is active or
if there is a communication fault.
VIF Display PWR Display
Energy Display Alarm Display