Rockwell Automation Energy Management Accelerator Toolkit Quick Start - Manual (Page 416)

416 Rockwell Automation Publication IASIMP-QS016C-EN-P - October 2014
Chapter 13 Time of Day Control
Load Configuration View
Click on the wrench button from the toolbar to display the load configuration view.
Faceplate Toolbar
Load Number to Configure
TOD Control Mode
Commands
Holiday Enable/Disable
Time and Date
Time of Day Schedule
Day of the Week to Configure
Button Icons Description
Alarm The alarm button indicates an alarm condition and activates alarm diagnostic views. A grey bell
indicates normal status, with no alarms. A red flashing bell indicates an alarm condition.
Home The Home button lets you view the status of all 16 loads.
Clock The Clock button displays the Time and Date Configuration View, which lets you update the PLC
clock
Calendar The Calendar button displays the Calendar Configuration View, which lets you assign holidays.
Help The Help button provides information for the existing view.
Close Click the Close button to close the faceplate.
Load Number The load currently being displayed/configured. To select a new load for configuration, click on
the load number to launch the numeric keypad input object. Enter a load number from 1…16,
then click Enter.
Load Description Click on the load description to launch the keypad input object and enter a description for the
load. When a description change is made, the Save Day Changes button background will turn
yellow, indicating that a change has been made, but has not been saved. The description change
will not take effect until it is saved. Click on the Save Day Changes button to save the change.
TOD Control Mode Click on the Mode Selection button to toggle between TOD Control, Override On, and Override
Off modes. When a mode change is made, the Save Day Changes button will turn yellow,
indicating a save is required. The mode change will not take effect until saved.
Copy/Paste
Commands
To copy the schedule from the displayed day to another day, click Copy Day. Select a new day,
and then click Paste Day. Click Save Day Changes to download the changes to the controller.
Save Command Click Save Day Changes anytime a change is made to the load configuration. You must save your
changes prior to selecting a new day or a new load to configure. If you select a new day or new
load prior to saving your changes, the changes will be lost.
Undo Command To revert to the previously saved schedule for the day, click Undo Day Changes. You can only
undo changes if they have not been saved. Once saved, you cannot revert to the previous
schedule.