Add distributed point i/o modules to the project, Introduction, Before you begin – Rockwell Automation 1768-L43 CompactLogix System Quick Start User Manual
Page 115: What you need, Add distributed point, I/o modules to the, Chapter 10, Introduction before you begin what you need
115
Publication IASIMP-QS003B-EN-P - October 2009
115
Chapter
10
Add Distributed Point I/O Modules to the Project
Introduction
In this chapter, you add distributed POINT I/O modules to your RSLogix 5000 project. You
also add ladder logic and download the project to the controller so you can test
communication with an I/O module. This project was created in
.
Before You Begin
•
Assemble the CompactLogix hardware (
).
•
Prepare the computer (
).
•
Prepare the POINT I/O hardware (
).
•
Configure your network (
or
)
•
Create a project in RSLogix 5000 software (
).
What You Need
•
POINT I/O modules needed for your application. This example uses a 1734-OB4E
module.
•
For a DeviceNet network (option 2), RSNetWorx for DeviceNet software.
•
For an EtherNet/IP network (option 1), no additional software is required.