Create a panelview plus application, Introduction, Before you begin – Rockwell Automation 1768-L43 CompactLogix System Quick Start User Manual
Page 161: What you need, Create a panelview plus, Application, Chapter 12, Introduction before you begin what you need
Publication IASIMP-QS003B-EN-P - October 2009
161
Chapter
12
Create a PanelView Plus Application
Introduction
In chapter 9, you used ladder logic in RSLogix 5000 programming software to create a push
button that controlled an status indicator on a digital output module. In this chapter, you use
FactoryTalk View Machine Edition software to create an application with a push button and a
multistate indicator that uses that ladder logic. You also transfer the application to the
PanelView Plus terminal to test communication with the controller.
Before You Begin
•
Prepare the CompactLogix hardware (
).
•
Prepare the computer (
•
Prepare the PanelView Plus terminal (
•
Cofigure your EtherNet/IP network (
).
•
Create a project in RSLogix 5000 programming software (
).
What You Need
•
FactoryTalk View for Machine Edition software