Prepare the distributed point i/o hardware, Introduction, Before you begin – Rockwell Automation 1768-L43 CompactLogix System Quick Start User Manual
Page 53: What you need, Prepare the distributed, Point i/o hardware, Chapter 3, Introduction before you begin what you need
53
Publication IASIMP-QS003B-EN-P - October 2009
53
Chapter
3
Prepare the Distributed POINT I/O Hardware
Introduction
In this chapter, you install the 1734 POINT network adapter and the 1734 POINT I/O
modules.
Before You Begin
•
Assemble your CompactLogix hardware (
•
Determine which of these network adapters to use:
– For an EtherNet/IP network (option 1), use the 1734-AENT adapter.
– For an DeviceNet network (option 2), use the 1734-ADN adapter.
•
Select the appropriate mounting base for the I/O modules:
– For the 1734-IT2I module, use the 1734-TBCJC mounting base
– For all other modules, use the 1734-TB or 1734-TBS mounting base.
What You Need
•
POINT I/O adapter: 1734-AENT or 1734-ADN
•
POINT I/O mounting bases: 1734-TB or 1734-TBS, and 1734-TBCJC
•
A digital POINT I/O module. This example uses 1734-OB4E, however, other POINT
I/O modules can also be used but are not required.
•
1794-PS3 or 1794-PS13 power supply
•
DIN rail
•
Standard CAT5 Ethernet cable for EtherNet/IP system (option 1)