Rockwell Automation 284D On-Machine ArmorStart Accelerator Toolkit - Manual (Page 100)

100 Publication IASIMP-QS015C-EN-P
Chapter 5 Faceplate Logix Integration
13. Click the Communication tab.
The communication properties are displayed.
Notice that the Path has not been identified.
14. Click Browse to enter the path.
a. Select the previous module followed by a
comma.
b. Enter 2 for the port of the scanner module.
c. Enter the DeviceNet node address of the
ArmorStart device that is communicated
with, to get the fault codes. For this example,
the Armorstart node address is 4.
Make sure all three entries are separated by
commas:
Dnet_ArmorStart_Module, 2, 4
15. Click OK.