Rockwell Automation 284D On-Machine ArmorStart Accelerator Toolkit User Manual
Page 19
Publication IASIMP-QS015C-EN-P - August 2011
19
Hardware Selection
Chapter 1
6. From the Control Voltage pull-down menu,
choose 24VDC.
This will be the default control voltage for
ArmorStart motor controllers connected to
the network. Other options are 120V AC and
240V AC. Control voltage might be
distributed by a Control Power network,
which you can also configure in the IAB
software.
A new three-phase power network is created
with a single branch and displayed in the
network view. Notice the tab added to the
network view and the display of the network
voltage. The gray box at the left end of the
network represents the power distribution
panel.
You can change the three-phase power
network voltage if needed by right-clicking
the distribution panel (the box at the left end
of the network) and choosing Change
Network Voltage.