Rockwell Automation 284D On-Machine ArmorStart Accelerator Toolkit - Manual (Page 185)

Publication IASIMP-QS015C-EN-P - August 2011 185
ArmorStart Configuration Using 193-DNCT Device Appendix C
Change Parameters
The parameter screens have slightly different formats for each parameter data type. The three different
parameter screen types are bit enumerated Boolean, numeric, and value enumerated.
Change a Bit Numeric Parameter
To change a bit numeric parameter follow these steps.
1. Select the desired parameter by completing steps
1…4 in Select a Parameter .
2. Press .
The following display appears.
3. Press .
4. Press
until you reach the designated
bit.
The description of the bit is listed below the
highlighted bit.
5. Use the numeric keypad to enter 1 to enable the bit or 0 to disable the bit.
You can also use the up and down to change the status of the bit.
6. Press .
Parameter Number
Bit Description