Metrohm tiamo 1.0 Manual - Manual (Page 329)

Commands 305
5.6.4 Track commands
The following track commands exist for the different tracks:
• START
Start command for Main track.
• TRACK
Start command for Normal track.
• SERIES START
Start command for Series start track.
• SERIES END
Start command for Series end track.
• EXIT
Start command for Exit track.
• ERROR
Start command for Error track.
• END
End command for all tracks.
START
Start command for Main track.
Appearance
The command has the following appearance:
Parameters
The parameters for the command START are configured on the following 3 tabs:
• General
General settings for the method run.
• Application note
Writing an application note which is displayed when starting a deter-
mination.
• Method variables
Configuring method and sample variables being available for the
method.