Metrohm tiamo 1.0 Manual - Manual (Page 449)

Commands 425
MEAS Upol
Command for amperometric measurements with selectable polarization volt-
age.
Devices
This command can be executed with the following devices:
Titrino: 702, 716, 718, 719, 720, 721, 736, 751, 758, 785, 794, 798, 799
Titrando: 808, 809, 835, 836, 841
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS Upol are configured on the following 4
tabs:
• General/Hardware
Parameters for device, sensor and stirrer.
• Measuring parameters
Parameters for the measurement.
• Evaluations
Defining further methods for evaluating measurement curves.
• Additional measured values
Defining further measured values which can be saved as additional
columns in the list of measuring points.
General/Hardware