Metrohm tiamo 1.0 Manual - Manual (Page 474)

450 Method
Request for buffer exchange
[ on ], off
If this option is enabled, a request for manual buffer exchange is displayed
after each measurement. This option must be disabled for automatic buffer
exchange when calibrating with a Sample Processor.
CAL MEAS pH
Measuring command for calibrating pH electrodes. The command is used to-
gether with the command
CAL LOOP pH .
Devices
This command can be executed with the following devices:
Titrino: 702, 716, 718, 719, 720, 721, 736, 751, 758, 785, 794, 798, 799
Titrando: 808, 809, 835, 836, 841
Appearance
The command has the following appearance:
Parameters
The parameters for the command CAL MEAS pH are configured on the following 2
tabs:
• General/Hardware
Parameters for device, sensor and stirrer.
• Measuring parameters
Parameters for the measurement.
General/Hardware