Metrohm tiamo 1.0 Manual - Manual (Page 460)

436 Method
[ 0 ] ... 999'999 s (for Window = Time )
Time for the lower limit of the window.
Upper limit
-20.0 ... [ 150.0 ] °C (for Window = Measured value )
Measured value for the upper limit of the window.
0 ... [ 999'999] s (for Window = Time )
Time for the upper limit of the window.
Additional measured values
Screenshot and parameters: see DET pH - Additional measured values
MEAS T/Flow
Command for temperature and gas flow measurements.
Devices
This command can only be executed with the 774 Oven Sample Processor.
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS T/Flow are configured on the following 4
tabs:
• General/Hardware
Parameters for device, sensor and stirrer.
• Measuring parameters
Parameters for the measurement.
• Evaluations
Defining further methods for evaluating measurement curves.
• Additional measured values
Defining further measured values which can be saved as additional
columns in the list of measuring points.
General/Hardware