Metrohm tiamo 1.0 Manual - Manual (Page 519)

Commands 495
SEND - properties
Command name
25 characters, [ Send # ]
Name of the command.
Send event messages
All the Event messages listed in the table are sent simultaneously. The table is not
editable directly.
Opening the dialog window Send event message for entering a new event
message.
Note
10 event messages can be entered at maximum.
Open the dialog window Send event message to edit the selected event
message.
Delete the selected event message.
SEND - event messages
Receiver
[ System ], Command
Selection of the type of receiver.
Selection
Command name, [ 'empty' ]
Selection of the command which a message should be sent to. All the
commands defined in the method are available for
Receiver = Command .
For Receiver = System this parameter is not editable.