Metrohm tiamo 1.0 Manual - Manual (Page 422)

398 Method
Conditioning
Screenshot and parameters: see SET pH - Conditioning
Additional evaluations
Screenshot and parameters: see SET U - Additional evaluations
Additional measured values
Screenshot and parameters: see DET pH - Additional measured values
KFT Upol
Command for Karl Fischer Titrations with amperometric measurement (select-
able polarization voltage).
Devices
This command can be executed with the following devices which have the KFT
mode:
Titrino: 720, 736, 751, 758, 784, 795, 799
Titrando: 835, 836, 841
Appearance
The command has the following appearance:
without conditioning with conditioning
Parameters
The parameters for the command KFT Upol are configured in the following 8 tabs:
• General/Hardware
Parameters for devices, dosing devices, sensors and stirrers.
• Start conditions
Parameters for the measurement of the initial measured value and for
defining the conditions which have to be met at the start of the titra-
tion.
• Control parameters
Control parameter for the endpoint (measured value for the endpoint,
titration rate, user defined parameters, stop criterion).
• Titration parameters
Parameters for the run of the titration.
• Stop conditions
Definitions of conditions which cause the stop of the titration.
• Conditioning
Switching conditioning on/off. Definition of start drift, drift correction
and stop condition.