Metrohm tiamo 1.0 Manual - Manual (Page 403)

Commands 379
• Conditioning
Switching conditioning on/off. Definition of start drift, drift correction
and stop conditions.
• Additional evaluations
Definition of additional methods for evaluation of the titrations curves.
• Additional measured values
Definition of additional measured values of other measuring com-
mands which are saved as additional column in the list of measuring
points.
General/Hardware
Screenshot and parameters: see DET U - General/Hardware
Start conditions
Screenshot and parameters: see SET pH - Start conditions
Control parameters
Command name
25 characters, [ SET U # ]
Name of the command.
The Control parameters can be set for each endpoint separately.
Endpoint 1
EP1 at
-2000.0 ... 2000.0 mV, [ off ] (Titrando),
-2000 ... 2000, [ off ] (Titrino)
Measured value for the first endpoint.