Metrohm tiamo 1.0 Manual - Manual (Page 436)

412 Method
[ automatic ]
If a temperature sensor is connected, the temperature will be measured
continuously. Otherwise the temperature manually entered under Tempera-
ture (see Measuring parameters) will be used.
off
The temperature will not be measured. The temperature manually entered
under
Temperature (see Measuring parameters) will be used.
Stirrer
Stirrer
[ 1 ] ... 4, off (Titrando only)
Selection of the stirrer. off means that no stirrer will be used.
Stirring rate
-15 ... [ 8 ] ... 15 (Titrando only)
Setting the stirrer speed. The direction in which stirring takes place changes
as the sign in front of the stirrer speed changes.
Switch off automatically
[ on ], off (Titrando only)
The stirrer is automatically switched off at the end of the command if this
option is enabled.
Measuring parameters
Command name
25 characters, [ MEAS pH # ]
Name of the command.
The measuring parameters are defined on this tab.
Measurement
The two measuring modes Measurement with drift control or Meas-
urement without drift control are selectable.