Metrohm tiamo 1.0 Manual - Manual (Page 635)

Subwindow Devices 611
Towers
On the tab Tower the tower parameters for the tower mounted on the 774 Oven
Sample Processor are shown. These cannot be edited, but must be set on the
device itself via the keyboard.
Max. stroke path
Shows the lowest permitted lift position for the tower. A lift height of 0 mm
corresponds to the "Rest position", i.e. the lift is moved right to the top.
Beaker sensor
Shows whether the beaker sensor for the tower is switched on or off. Each
time that a sample position is moved to the beaker sensor checks whether
a beaker is present or not.
Rack
On the tab Rack the rack-specific data of the attached rack are shown.
Rack name
Shows the name of the attached rack. If no rack is in position then " ----- " will
be shown.
Rack code
Shows the rack code of the attached rack. The rack code corresponds to
the arrangement of magnets on the base of the rack and is read in by the
Sample Processor in order to recognize the rack. If no rack is in position
then the display will be empty.