E-flite Deuces Wild 25e2 ARF - Manual (Page 10)

10 E-flite Deuces Wild Assembly Manual
Rudder and Elevator linkage Installation
Required Parts
Fuselage assembly Nylon clevis (2)
Silicone clevis retainer (2) Nylon pushrod keeper (2)
29 3 / 4
-inch (755mm) pushrod wire (2)
Required Tools and Adhesives
Pin drill Drill bit: 5/64-inch (2mm)
Felt-tipped pen Pliers
Side cutters Phillips screwdriver: #1
 1. Thread a clevis onto one of the 29 3 /
4
-inch (755mm)
pushrod wires. Make sure to slide a silicone clevis
retainer onto the clevis before threading it onto the
pushrod wire.
 2. Slide the pushrod wire into the pre-installed pushrod
tube on the same side of the fuselage as the elevator
control horn. Attach the clevis to the elevator control horn
in the middle hole.
 3. Use a pin drill and 5/64-inch (2mm) drill bit to
enlarge the outer hole of the elevator servo horn.