E-flite Deuces Wild 25e2 ARF - Manual (Page 60)

60 E-flite Deuces Wild Assembly Manual
Control Throws
 1. Turn on the transmitter and receiver of your Deuces
Wild. Check the movement of the rudder using the
transmitter. When the stick is moved right, the rudder
should also move right. Reverse the direction of the servo
at the transmitter if necessary.
 2. Check the movement of the elevator with the radio
system. Moving the elevator stick down will make the
airplane elevator move up.
 3. Check the movement of the ailerons with the radio
system. Moving the aileron stick right will make the right
aileron move up and the left aileron move down.
 4. Use a ruler to adjust the throw of the elevator, ailerons
and rudder. Adjust the position of the pushrod at the
control horn to achieve the following measurements when
moving the sticks to their endpoints.
Ailerons High Rate Low Rate
Up 5/8-inch Up 3/8-inch
Down 5/8-inch Down 3/8-inch
25% Expo 10% Expo
Elevator High Rate Low Rate
Up 7/8-inch Up 1/2-inch
Down 7/8-inch Down 1/2-inch
20% Expo 10% Expo
Rudder High Rate Low Rate
Left 1 1 /
4
-inch Left 1/2-inch
Right 1 1 / 4
-inch Right 1/2-inch
15% Expo 0% Expo
Flaps Takeoff Landing
1 1 /
8
-inch 5/8-inch
Elevator Compensation With Flaps
3/32-inch down 5/32-inch down
Note: Measurements are taken at the widest point on
the surface.
These are general guidelines measured from our own flight tests.
You can experiment with higher rates to match your preferred
style of flying.