E-flite Deuces Wild 25e2 ARF - Manual (Page 43)

43 E-flite Deuces Wild Assembly Manual
 9. Attach a T-fitting to the air line from the previous step.
On one side of the T-fitting, attach a 3-inch (76mm)
section of air line to the actuator valve. On the other side,
connect a 6-inch (152mm) section of air line, then a male
quick disconnect that mates to the female disconnect on
the nose gear retract line.
 10. Connect a 6-inch piece of air line to the remaining
fitting on the actuator valve. A female quick disconnect
that mates to the male quick disconnect on the line
coming from the air tank will need to be attached to
this line.
 11. Remove the servo horn from the retract servo. Use a
pin drill and 5/64-inch (2mm) drill bit to enlarge to outer
hole of the retract servo horn.
 12. Slide the brass pushrod connector in the hole drilled
in the previous step.