E-flite Deuces Wild 25e2 ARF User Manual
Page 38
Advertising
38
E-flite Deuces Wild Assembly Manual
22. Use a covering iron to iron the covering inside the
edges of the retract opening.
23. Position the main landing gear in the opening in
the wing. Use a pencil to transfer the locations for the
mounting screws on to the landing gear rails.
24. Use a drill and 3/32-inch (2.5mm) drill bit to drill the
locations for the four screws.
25. Apply 2–3 drops of thin CA into each of the holes.
This will harden the surrounding wood and provide a
harder surface for the screws, helping prevent them from
pulling loose.
Advertising