E-flite Deuces Wild 25e2 ARF - Manual (Page 45)

45 E-flite Deuces Wild Assembly Manual
 15. Thread a clevis onto a the 3-inch (76mm) pushrod
wire. Make sure to slide a silicone clevis retainer onto
the clevis before threading it onto the pushrod wire. Slide
the pushrod into the pushrod connector and align the
clevis with the hole in the actuator valve. Now hook up
the clevis and set the valve to where the plunger is half
way in between either side. Using threadlock, tighten the
machine screw and proceed to the next step.
 16. Now with the radio on, flip the retract switch to either
side and in the travel adjust menu continue to dial in
throw on one side until the plunger just touches one side.
Now flip the retract switch in the opposite direction and
turn the travel adjustment up until the plunger just touches
the opposing side. Your retract servo should now be set
up and not binding. Trim the pushrod with side cutters
once you have the final adjustments complete.