E-flite Deuces Wild 25e2 ARF User Manual
Page 11
Advertising
11
E-flite Deuces Wild Assembly Manual
4. Center the elevator servo using the radio system. With
the elevator in the neutral position, use a felt-tipped pen
to mark the pushrod wire where it crosses the outside
hole on the servo horn.
5. Use pliers to bend the pushrod wire 90 degrees at the
mark made in the last step.
Note: Use side cutters to trim any arms that will interfere
with the operation of the rudder servo.
6. Using a #1 Phillips to remove the servo horn from
the servo. Slide the servo horn onto the pushrod wire
with the splined part of the horn that fits onto the servo
toward the bend.
Advertising