E-flite Deuces Wild 25e2 ARF - Manual (Page 32)

32 E-flite Deuces Wild Assembly Manual
 3. Position the nose landing gear in the opening in the
fuselage. Use a pencil to transfer the locations for the
mounting screws on the landing gear rails. Position the
unit as far forward as you can while still allowing the
nose gear to steer left and right.
 4. Use a drill and 3/32-inch (2.5mm) drill bit to drill the
locations for the four screws.
 5. Apply 2–3 drops of thin CA into each of the holes.
This will harden the surrounding wood and provide a
harder surface for the screws, helping prevent them from
pulling loose.
 6. Cut a 10-inch (254mm) piece of air line. Attach the
air line to the fitting on the nose gear retract.