E-flite Deuces Wild 25e2 ARF User Manual
Page 27
Advertising
27
E-flite Deuces Wild Assembly Manual
2. Use a drill and 3/32-inch (2.5mm) drill bit to drill the
locations for the four screws.
3. Apply 2–3 drops of thin CA into each of the holes.
This will harden the surrounding wood and provide a
harder surface for the screws, helping prevent them from
pulling loose on a hard landing.
4. Secure the main gear in the wing center section
using a #2 Phillips screwdriver and four 3mm x 8mm
self-tapping countersink screws.
5. Repeat Steps 1 through 4 to install the remaining main
landing gear.
Advertising