E-flite Deuces Wild 25e2 ARF - Manual (Page 9)

9 E-flite Deuces Wild Assembly Manual
 2. Slide the threaded rods from the fin into the holes in
the stabilizer. The fin will fit flush against the stabilizer
when installed.
 3. Slide the threaded rods into the holes in the rear
of the fuselage.
 4. Using a 1/4-inch nut driver, secure the tail assembly
to the fuselage using two 4-40 lock nuts and two #4
washers. Do not over-tighten the nuts and damage the
fuselage. At this time the Rudder/Fin, Stab/Elevator, and
Fuselage should fit tight against each other.