E-flite Deuces Wild 25e2 ARF User Manual
Page 54
Advertising
54
E-flite Deuces Wild Assembly Manual
5. Use hook and loop tape to attach the speed control to
the inside of the motor nacelle.
6. Test fit the motor nacelles to the wing. The E-flite decal
will face out toward the tip of the wing.
7. Once satisfied with the fit, remove the nacelle from the
wing. Use 6-minute epoxy to glue the nacelle to the wing.
Apply the epoxy to the exposed bare plywood of the
wing, which is the junction where the nacelle meets the
wing. Also apply epoxy to the inside of the nacelle where
it will meet the plywood. Make a nice fillet of epoxy at
this joint. Use low-tack tape to hold the nacelle in position
while the epoxy cures.
Advertising