E-flite Deuces Wild 25e2 ARF - Manual (Page 16)

16 E-flite Deuces Wild Assembly Manual
Aileron Servo Installation
Required Parts
Wing panel (right and left) Servo hatch (right and left)
Servo mounting block (4) Servo w/hardware (2)
Nylon clevis (2) Silicone clevis retainer (2)
Nylon pushrod keeper (2)
2mm x 10mm self-tapping screw (8)
4 1/4-inch (108mm) aileron pushrod wire (2)
Required Tools and Adhesives
Pencil 6-minute epoxy
Drill Pin drill
Phillips screwdriver: #1 Thin CA
Felt-tipped pen Pliers
Mixing cups Mixing sticks
Side cutters Sandpaper
Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm)
 1. Use sandpaper to roughen the ends of the four servo
mounting blocks. Doing so will allow the epoxy applied
to them in the next step a better surface to adhere to.
 2. Use 6-minute epoxy to secure the servo mounting
blocks on the servo hatch. The positions for the blocks
have been etched onto the hatch for your convenience.