E-flite Deuces Wild 25e2 ARF - Manual (Page 8)

8 E-flite Deuces Wild Assembly Manual
 8. Plug a 3-inch (76mm) servo extension into the throttle,
aileron and flap ports on the receiver at this time. This
will make it easier to plug the leads that will be installed
in the wing later while assembling your aircraft.
Note: If you are installing retracts, plug a 3-inch (76mm)
extension into the port marked GEAR at this time as well.
Tail Attachment
Required Parts
Rudder/fin Elevator/stabilizer
Fuselage assembly Nylon control horn
4-40 lock nut (2) #4 washer (2)
Required Tools and Adhesives
Nut driver: 1/4-inch
 1. Thread the nylon control horn onto the rudder
torque rod. You will thread this on until the end of
the rod is flush with the nylon control horn.