E-flite Deuces Wild 25e2 ARF - Manual (Page 13)

13 E-flite Deuces Wild Assembly Manual
 11. Thread a clevis onto one of the 29 3 /
4
-inch (755mm)
pushrod wires. Make sure to slide a silicone clevis
retainer onto the clevis before threading it onto the
pushrod wire.
 12. Slide the wire into the rudder pushrod tube and
connect the clevis to the rudder servo horn. Plug a
Y-harness into the receiver rudder port of your receiver.
The rudder and nose wheel steering servo will plug into
this Y-harness.
Note: Use side cutters to trim any arms that will interfere
with the operation of the rudder servo.
 13. Center the rudder servo using the radio system. With
the rudder in the center position, use a felt-tipped pen to
mark the pushrod where it crosses the hole in the rudder
control horn.