E-flite Deuces Wild 25e2 ARF - Manual (Page 34)

34 E-flite Deuces Wild Assembly Manual
 10. Remove the wheel from the fixed nose gear using
a #2 Phillips screwdriver to loosen the screw that
secures the wheel collar. Slide the wheel collar without
the screw onto the nose gear wire, then the nose wheel.
Use the wheel collar from the fixed gear to secure the
wheel on the retract strut. A #2 Phillips screwdriver and
threadlock is used to tighten the screw that secures the
collar to the axle.
Note: The wheel is shown on the building surface for
clarity and contrast.
 11. Remove the nose gear steering servo horn from the
steering servo. Use a pin drill and 5/64-inch (2mm) drill
bit to enlarge to outer holes of the steering servo horn.
 12. Slide the two brass pushrod connectors in the holes
drilled in the previous step.